To replace the wiper motor on your Ford F-250 you're first going to need to clean off the front of the vehicle. Now pull up and remove your wiper blades. They will have a small latch holding them in place and you'll need to undo it and snap them out of place. Now open up the hood of the truck and you'll want to look underneath the wipers usually are. Right below the wiper at the back of the engine near the firewall you're going to see the motors. You'll need to unbolt and disconnect them. Once you have them undone you can install the new ones.
Ray
June 21, 2023
I bought new pigtail for wiper motor the old one was toast but the wires aren’t color coded
Seth S.
April 10, 2020
To replace the windshield wiper motor on a ford f250 you would take the following steps: remove the cowl and any covers over the wiper motor and transmission assembly. Remove the plug harness to the motor and disconnect the wiper transmission arm from the wiper motor. Remove the bolts holding the motor and transmission assembly to the body of the car. Install the new motor. The plug harness is usually keyed so it can only be inserted in one direction. If not, the proper polarity must be observed. Bolt the motor to the car body. Cycle the motor several times by turning it on and off to establish the park position, then re-attach the linkage transmission assembly to the wiper motor. Install all covers, cowling, and so forth and test operation of the motor on a wetted glass only.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.