Disabling the front parking sensors on a Ford Ranger is as simple as pushing the parking sensor button, which can be found to the left of the red hazard warning triangle on Your panel. This should toggle the sensors between different modes, so push it until they turn off. If You wish to turn them on, or set them to a specific mode, simply push the same button until the desired effect is achieved. Typically, You can toggle all sensors to work, but also use only the side, front or rear ones if Youve chosen those upgrades when purchasing Your Ranger. Installing additional sensors, such as front sensors can be somewhat expensive, and typically cost about $450-$500 to install. Though most of that cost goes into labor.
Don
September 8, 2020
Can the sensor button be rebooted
Francis L.
April 10, 2020
The parking sensors can be disabled by pressing the p button to the left of the hazard warning triangle.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.