First, make sure that the 2010 Mitsubishi Lancer is on level flat ground. Check the tire pressure for each of the tires, and make sure they are within the correct psi. If You look on the side of the tire it should have the psiAmount stamped on. Once this is done You will want to get in the car and turn on the power but do not start the engine. To the right of the steering wheel is a button that will be labeled tpms or something close. Hit this and hold it down until it begins to blink. Once it blinks leave the car sit for about 20 min, as it will take this long for it to recalibrate. When it stops blinking You can shut the car off and then turn it back on to make sure the reset worked.
Samantha A
July 16, 2020
To reset the tire pressure monitor or tpms system in your 2010 mitsubishi lancer turn the ignition key to the "on" position and depress the tpms button, usually located under the dash, until the tpms light blinks several times. Start your vehicle and let it run for at least 20 minutes and your tpms system should be reset.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.