The Chrysler 300 has one fuel pump.The fuel filter on the car is a part of the fuel pump. In most cases the fuel pump is along the underside of the vehicle, attached to the fuELRail. Getting to it is quite simple, as it is only held in place by a couple of bolts, and these are easy enough to remove. The replacement cost can vary and is between 200 and 800 on average. In some cases however You will find the filter and pump are an internal part of the gas tank. If this is the case then You will need to get a new gas tank to replace the pump, but there will be external access to put a new filter in. Prices for this are about the same, maybe a few hundred more than just the pump. If the pump is failing then You will notice that You have trouble accelerating, as You are not getting enough gas. In some cases You wont be able to start the car at all.
Wilma K
December 8, 2020
The chrysler 300 is equipped with both a main and secondary fuel pump.
Evelyn Bryant-Banks
July 13, 2022
Just replace the driver side fuel pump car still want Crunk. What could be now?
Mike
July 2, 2023
I had the same problems I had to replace the passenger side pump the hose going to drivers side had a hole in the line been running perfect
Check under the engine and see if you are getting gas from the sending unit located in the passenger side rear seat clean the filter or replace
Mac
August 28, 2022
I'm having the exact same problem...replaced drivers side pump and its still not turning over
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.