The purpose of the TPMS on Your 2018 Dodge Durango is to warn You that one or more tires is under-inflated which could produce premature tire wear, tire failure, and unsafe driving conditions. To perform a reset of the TPMS only takes a few moments. First, turn the ignition to the "ON" position without starting the vehicle. Now, press the "Reset" button (which is found to the right of the steering wheel) until You see the tire pressure light blink three times and then release the button. Start the vehicle and wait for at least 10 minutes for the sensors to refresh. You have completed the procedure and the TPMS has successfully been reset.
Joe B
April 27, 2022
This answer above is 100% completely incorrect! There is no reset button used for the sensors on these vehicles. Where do you people come up with this nonsense? The vehicle will learn the sensors automatically, as long as you install the correct ones for your vehicle! Just drive the car and in a short time the will start reading the pressure.
Alvaro C
July 16, 2020
To reset the tpms on the 2018 dodge durango make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes. If the sensor is not working correctly then you may have tires with incorrect pressure, and the car can get bad performance.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.