As the owner of a Chevrolet Colorado, You may find Yourself needing to progRam Your new key fob. This is easy to do, and takes about 3 or 4 minutes. The first thing You will need to do is sit down on the driver's side. Next, make sure all of the doors are fully closed. Push down and hold the unlock button found on the driver's side power lock panel. When You take Your finger off the button, You will hear the doors lock and unlock one time. This indicates You are now in reprogRam mode. Push down the unlock and lock buttons simultaneously, for around 30 to 40 seconds, until the doors unlock and lock a second time. Finally, turn Your ignition to the on position, then back off.
Nathaniel B.
April 9, 2020
To program your key fob for your chevy colorado sit in the driver's seat of the truck and close all of its doors. Put the key in the ignition. Press and hold the "unlock" button on the power lock panel of the driver's side door. While holding the "unlock" button, turn the ignition key to "run," then cycle it back to "off." Repeat this sequence one more time. Release the "unlock" button--the door locks will lock, then unlock, to notify you that the truck is in programming mode. Press and hold both the "lock" and "unlock" buttons until the door locks cycle again. Turn the key to the "run" position to exit programming. Turn the key to the "off" position to remove it from the cylinder.
Didn’t work for 2022 ZR2. Did anyone else in the comments figure it out?
Frank
February 6, 2023
Did not work on my 2015 Colorado either
Carl
November 2, 2022
This procedure did not work on my 2016 Colorado
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.