You can do this by turning the ignition off and on. This should reset Your brake warning light if it is not defective. Otherwise, You will need to have it repaired or replaced if it stops functioning out of nowhere. This can be a problem in the long run which needs to be addressed as early as possible. This brake warning light there is to alert the driver of any issues with the anti-lock braking system or the brake system that Your car has been supplied with. It can also turn on to indicate low levels of brake fluid for the master cylinder or the anti-lock braking systems reservoir. It is always a good idea to have a can of extra brake fluid in Your trunk at all times.
My work van had the same fault, tried turning it off and back on still there so I pulled the abs and brake system fuses while running and waiting 30sec and put them back inrestarted the van but the fault still there, drove the van for about 15 min and parked up came back drove it again and all fault were cleared
Stanley D
July 30, 2020
To reset the Mercedes Sprinter braker wear light if it is not damaged you can turn the ignition on and then off again once the repairs are done.
Don
January 23, 2024
I have same issue.Merc sprinter.I think taking the.Battery lead off for 10 minutes.Will clear the codes and warning lights
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.