The front driveshaft on the Ford Explorer helps transfer power and torque from the transmission to the wheels, working with the suspension's axles and CV joints. To replace the part, raise the vehicle on a professional lift or jack stands to gain access to the driver's side wheel well area. Tools needed on most Explorers include a T30 driver, a hammer, 8mm socket, ratchet and extension and a pry bar or screwdriver. The rear of the driveshaft connects with SRX 8mm bolts and the front is secured with four T30 torque bolts. Use a pry bar or screwdriver to hold the rear yoke while You unbolt the front of the driveshaft with an extension and the 8mm socket. Employ a pry bar and hammer to shift the shaft side of the flange and move it away from the transfer case end, freeing the shaft from the yoke. Repeat this process at the other end, using a T30 driver.
Inga A.
April 10, 2020
To remove the front drive shaft on a ford explorer you should take the following steps: locate the four retaining bolts, remove them with a wrench and pull the shaft off the transfer case. You may need to rotate the drive shaft to get to all the bolts. Shift the transfer case into neutral, allowing it to spin freely. Remove the front drive shaft from under your chevy and perform any needed repairs.
Stacy C.
April 10, 2020
Using a torx bit, the front drive shaft can be disconnected to force the vehicle to rely on rear wheel drive.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.