Resetting the airbag light in Your 2003 Honda Accord is a very easy task. It will only take around 4 to 8 minutes of Your time. First, go to the driver's side of Your vehicle, and get inside. Next, place Your key in the ignition, and turn it to the on position. Make sure when You do this that You don't start the engine. You will see the srs light appear for a few seconds, then disappear. Go to the front of Your vehicle and disconnect the positive terminal from Your battery. When You note that the srs light has reappeared, go back to the battery and re-attach the terminal. This should reset the airbag light.
Willie D.
April 9, 2020
Remove ecu service connector 2 to reset airbag light on a 2003 honda accord shut off ignition switch. Link (jump) the mes connector (this is a 2-pin yellow connector wrapped in yellow plugged in the front of the fuse box underdash) 3. Switch the ignition on 4. After the light goes out, srs light will come on for 6 secs then go out, detach the jumper within 4 secs. 5. The srs light will come on again, the jumper will be reconnected within 4 secs after the light has switched on. 6. The srs light is out, the jumper is replaced in 4 secs after the light has gone out. 7. The srs light blinks twice showing the reset memory.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.