The 2005 Chrysler 300 does not have a way to reset the fuel pump. You have a fuel pump relay which might be the problem. A faulty fuel pump relay prevents Your engine from running as the fuel is not supplied. There are many signs of a bad fuel pump relay including loss of power, engine not starting, pump not making the common noise, and vehicle catching on fire. If the fuel pump relay has an issue while the vehicle is operating it will cut off power to the fuel pump, which will cause the engine to stall. A faulty relay may allow the vehicle to be restarted a short while later, while a completely failed relay will not.
Michael M
July 16, 2020
To reset the 2005 chrysler 300 fuel pump you will locate the inertial trigger or airbag control module of your car. The owner's manual should give you the exact location, but if you don't try looking inside the center console, under the front seats, behind the glove compartment, or behind the driver's or passenger-side kick panels. Press the button on the inertial switch; this should be properly identified as the reset of the fuel pump and may be in a different color to the case. Remove the inertia switch cover by either loosing the plastic clips or removing the screws that hold it in place. You'll see one of three things inside the switch: a button, a circuit breaker-type switch or a fuse. Push the button or flip the switch back to its original position.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.