Before resetting the light belonging to the tire pressure monitoring system in Your 2006 Hyundai Tucson, check the air pressure in all four tires using a pressure gauge. Locate the TPMS reset button, which should be beneath the steering wheel. It looks like the outline of the sides and bottom of a tire with a dot and two arrows in the middle. The word SET should be beneath it.Turn the key in the ignition to the ON position without starting the vehicle. Push and hold the reset button for about 3 seconds. The lights should begin blinking. Start the engine and drive the vehicle at speeds of 30 to 60 mph for 20 to 25 minutes to finish the calibration process. If You're having trouble resetting the light, You can disconnect the positive battery terminal, give it time to drain, and then reconnect, and the warning light should go away.
Angelina B
July 16, 2020
To reset the 2006 hyundai tucson tpms, press the tpms reset button and keep it until the light flashes three times, and then release it. Start the car and let the sensor run for 20 minutes. Typically, you can consider the tire pressure control reset button under the steering wheel.
Tl
September 21, 2022
Nope no reset
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.