As the driver of a 2013 Dodge Dart, You may at some point encounter the need to reset the Uconnect in Your vehicle. This is easy to do, and will only take about 3 to 5 minutes of Your time. The first thing You will need to do is open the door on the driver's side of Your car, and get inside. Next, look at the controls on Your steering wheel, in the center. Press down and hold the phone button and the VR button simultaneously. Turn Your ignition off, and open Your door. Wait for a count of 30 to 40 seconds, then close the door again. Start the engine, and the Uconnect will be reset.
Daniel C
July 16, 2020
To reset the uconnect on the 2013 dodge dart you need to hold down the vr and phone buttons on the wheel while the vehicle is on. Then turn off the vehicle and open the door for thirty seconds.
Martin
November 6, 2022
Merci beaucoup pour le truc….. 😉 cela a fonctionné sur ma Dart 2013… depuis plusieurs jours je cherchais la manière de réinitialiser ma radio Uconnect…
Tried that but still did not work. Any help here would be great.
Aden S.
January 19, 2023
2015 Dart Owner here, and holy s**t is this the worst bluetooth system on earth. Another way I go about it is disconnecting your already connected device from the car screen where it says “Paired Phones”. Disconnecting this should disconnect from both the phones, and audio sources tab. Once disconnected, FROM YOUR PHONE, go to bluetooth and press the “Uconnect” option. This should now show your phone being connected on the Phones tab, but NOT the audio tab. Wait around 10 seconds before navigating to the Audio Sources tab ON YOUR CAR and connect to the device from there. This should fix minor skipping for the duration of your drive. If for some reason it doesn’t, then just do the above. Just a shorthand way I’ve found to fix the issue.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.