How do I replace the 2017 Ford Expedition backup camera?

I'm assuming You've already purchased a replacement camera for Your 2017 Ford Expedition; if not, Master Tailgaters makes an OEM compatible part, FL1Z-19G490-B, that You can usually snag for around $160. You should already have the correct wiring running from the back of the vehicle to the front wiring harness, so You shouldn't need to worry about running the cables, but pay attention to voltages. You should be able to just leave the installed wires where they are, around the trunk liner. Remove the two T20 Torx screws holding in the driver's side tail light, and it'll just pop out, allowing You access to the camera. You may need to solder the wires for the new camera, if there isn't pre-existing molex, but basically, You're juSTSwitching out the part at this point, matching the wiring coloring, and then just reversing takeng out the light to finish up.