How do i reset the 2015 Jeep Renegade tire pressure?

To reset the tire pressure on the 2015 Jeep Renegade You will need to use a TPMS scan tool that has an OBD module and a TPMS activation tool. You will want to first make sure the TPMS sensors are properly working. Set the tire pressure to the recommended level which can be found inside the door. The suggested pressure for all wheels iS35 psi. Next, the TPMS tool should be held near the valve stem on the tire sidewall starting with the front left. Do the same for the front right, rear right, and rear left. The OBD module is to be applied to the data link connector. Turn on the ignition and press OK on the TPMS tool. Once the data transfer is complete You can disconnect the OBD module. Turn off the ignition and then back on again. Drive the car at a speed of 28 mph for a MINImum of five minutes. At this point the relearn procedure is done.