The 2008 Ford Escape v6 transmission fluid type is dexron ATF-4. To change the transmission fluid You will want to first make sure the car is level on the ground and then pop the hood open. Now locate the transmission fluid container, it should be on or near the transmission itself, and find the dipstick. Pull it out and wipe it clean, then put it back in and pull it back out. Note the amount of fluid it says is in there, and how much You need to put in to fill the container. Use a funnel and top of the container until it is full, or right at full. Being a smidge under is fine, but do not overfill. Now close up the container and You are good to go.
Mark S.
October 31, 2021
Owners manual for the 2008 Ford Escape 3.0L V6 specifies Automatic Transmission fluid 10.2 quarts of Motorcraft MERCON V ... ATF7
David r.
October 21, 2021
It is mercon V for a 2008, I own one and just replaced my fluid.
Lance Walker
February 25, 2021
The dip stick clearly says to use Mercon LV
Roman S.
April 9, 2020
The 2008 ford escape uses the type f automatic transmission fluid.
Paul T.
April 9, 2020
The 2008 ford escape v6 transmission fluid type is dexron.
Dave W
October 31, 2021
My dipstick says Mercon V. Be sure to check the fluid level hot with engine running.
Steven
September 24, 2022
Can I use Dax Mark ATF fluid in a 2008 Ford Escape
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.