The amplifier on the 2011 Chevy Traverse is located behind the radio itself. You will need to remove the radio in order to get to it. If the amp is not working then You more than likely have a bad fuse. The fuse for it is in the box that is to the left of the steering wheel. To get to the fuse box look to the left of the steering wheel and find a small seam or crack along the dash. Using a screwdriver or prybar You will want to pop this open. On the inside, You will find a bunch of fuses. On the back of the panel that You pulled open, You will see a diagram that will show You what each of the fuses is for. If this is not on the back of the panel then You can also find it in the owner's annual for the vehicle. Once You have figured out which fuse You need simply pull it out. The two sections that stick up should be connected by a thin strip of metal. If this has been broken then the fuse is no good and will need to be replaced. If this strip is there then the fuse is fine and can be popped back in. New fuses will cost You about 10 dollars, so they are pretty cheap.
2011 chevy traverse factory amp below steering wheel bolted to the body control modual
Ilean
June 17, 2022
I have a 2011 Chevy Traverse and that is NOT where the fuse are. They are up underneath the glove box
Mk
November 28, 2021
2009 traverse and 2010 acadia could not find amplifier where everyone is pointing at. Even went to the junkyard found some similar cars (traverse/acadia) with amp and some dn’t. My 2010 acadia works fine even with no visible amp but traverse no
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.