The transmission dipstick for a 2006 Toyota Tundra truck is located on the passenger side of the engine compartment, near the back of the engine. It is used for measuring the fluid if You are going to change the fluid out. To change the transmission fluid You will want to first make sure the car is level on the ground and then pop the hood open. Now locate the transmission fluid container, it should be on or near the transmission itself, and find the dipstick. Pull it out and wipe it clean, then put it back in and pull it back out. Note the amount of fluid it says is in there, and how much You need to put in to fill the container. Use a funnel and top of the container until it is full, or right at full. Being a smidge under is fine, but do not overfill. Now close up the container and You are good to go.
Highlander
December 5, 2021
2005 - 2006 Toyota Tundra 4.7L V8 DOES NOT have a dipstick to check the transmission fluid.
Jim Rawling
August 20, 2021
There is not a dipstick for the transmission on my 06 tundra.
Nathan E.
April 9, 2020
The transmission dipstick for a 2006 toyota tundra truck is located on the passenger side of the engine compartment, near the back of the engine.
RANDY FOX
September 13, 2021
There may be a dipstick on the passenger side of the 4 cylinder version, but the v8 version does not have one. See a qualified repair/service facility or the dealer.
Jimmy Kline
January 28, 2023
I have a 06 Tundra There is NoTransmission Dip stick to check Fluid
John W
December 19, 2023
You'll find no dipstick on a 2006 Toyota Tundra 4.7L because it's a sealed transmission. There is a fill "Plug" near the top of the transmission, the fluid is pumped into the transmission until it starts overflowing then is replugged. There is a drain plug at the bottom of the transmission.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.