How do I perform the 2013 Toyota Sienna reset tire pressure light?

eyeOutline 4558 messagesOutline 2
star Top Answer
accountCircle
Margaret W. February 2, 2021
If You want to reset the tire pressure light on the 2013 Toyota Sienna, this is where You need to be. What You're going to do first is adjust the tire pressures on each tire by adding air according to the psi stated for Your vehicle. Then, go ahead and turn the engine on. You're going to press and hold onto the reset button located on the right of the instrument panel by Your steering wheel. Then, You're going to keep holding it until the TPMS light flashes three times slowly. When it does flash, You can let go of the button. Go ahead and leave the car running for a few minutes so that the system can register the reset and You should be good to go.
accountCircle
Jamie J July 16, 2020
To reset the tire pressure monitor or tpms system in your 2013 toyota sienna vehicle, turn the ignition key to the "on" position and depress the tpms button, usually located under the dash, until the tpms light blinks several times. Start your vehicle and let it run for at least 20 minutes and your tpms system should be reset.
Leave your answer
Name
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com does not research or authenticate any of the Answers provided.