Resetting the tire pressure monitoring system (TPMS) in Your 2016 Jeep Patriot needs to be done after You've changed the cold air pressure in Your tires. You can find the recommended pressure on the placard inside the frame of the door. To reset the system and turn the light off, turn the key in the ignition to ON, but don't start the engine. Locate the reset button beneath and to the left of the steering column. Press that button and hold it until You see the low pressure light blink on the display three times. When this happens, release the button. Start the engine and allow it to run at least 20 minutes. This gives the system time to receive an air pressure reading from all four sensors. Turn the ignition off and then start the vehicle again to make sure the light isn't on. If You have trouble the first time, try driving the vehicle for 20 minutes rather than just allowing it to run.
Daniel Leys
September 26, 2021
2016 has an auto reset. There is NO RESET BUTTON for the 2016.
To reset the 2016 jeep patriot tire pressure sensor simply hold the reset button down until the tpms indicator light in the instrument panel blinks slowly 3 three times.
Carrie
September 24, 2022
2016 does not have a reset button I just bought car a month ago and light came on today and all my tires been at 30 I put them to 35(recommended) it did not go off after me driving..I put the ignition to on position went inside a store and when I came out and started it the light is now off..put key in on position and wait abojt 20 min
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.